问题原文
原帖链接 · Mihai · CC BY-SA 3.0
If I add a new DNS server using nmcli connection modify eth0 +ipv4.dns 8.8.8.8, I still have to update /etc/resolv.conf for the resolver to pick up the changes, right? So how do I force the update?
The only way I found was restarting the network service: /etc/init.d/network restart. Is there a less invasive way -- a nmcli command, perhaps?
已采纳解答
原帖链接 · maximbr · CC BY-SA 3.0
based on http://www.certdepot.net/rhel7-configure-ipv4-addresses/
nmcli connection up eth0
run after mod calls, worked for me.
P.S. you can use "nmcli -p connection show eth0" to see the configured vs active settings
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
