问题原文
原帖链接 · automationcoach · CC BY-SA 4.0
I am looking at the state of an interface on a Linux system. When I use the ifconfig command it shows that the link is UP.
master $ ifconfig docker0
docker0 Link encap:Ethernet HWaddr 02:42:b9:25:be:2d
inet addr:172.18.0.1 Bcast:0.0.0.0 Mask:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
However, when I run the ip link command , it is down.
master $ ip link show docker0
3: docker0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue state DOWN mode DEFAULT group default
link/ether 02:42:b9:25:be:2d brd ff:ff:ff:ff:ff:ff
Can someone please explain?
社区高分解答
原帖链接 · Anton Danilov · CC BY-SA 4.0
In the ifconfig UP flag means the administrative status, not link status. If you have 'link up', then RUNNING flag is present in the ifconfig output. Anyway, ifconfig is deprecated, use the ip tool.
In the ip tool link status is shown by flags LOWER_UP and NO-CARRIER.
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
