问题原文
原帖链接 · Tim Autin · CC BY-SA 4.0
I just purchased a server from Hetzner, with two 4TB hard drives and one 1TB SSD. I want to setup the two hard drives (/dev/sda & /dev/sdb) in RAID1 and install the OS on them, and have the SSD (/dev/sdc) as an extra drive.
Until now, all my tentatives failed. The installimage script runs fine, and tells me that I just need to reboot. But when I reboot, I have this error:
I tried fixing the error without luck and gave up, as I suspect that the problem comes from my installimage script config.
Here's the configs I used for all my tries:
DRIVE1 /dev/sda
DRIVE2 /dev/sdb
#DRIVE3 /dev/sdc # commented to exclude it from the RAID setup
SWRAID 1
SWRAIDLEVEL 1
BOOTLOADER grub
HOSTNAME EX51
And here are the different partitioning schemes I tried:
1°) Nearly the default config
PART swap swap 32G
PART /boot ext3 512M
PART / ext4 all
2°) A try with LVM
PART /boot ext3 512M
PART lvm vg0 all
LV vg0 swap swap swap 4G
LV vg0 root / ext4 all
3°) Partitions smaller than 2TB in case that the system does not use grub2 (is it?)
PART swap swap 32G
PART /boot ext3 512M
PART / ext4 1T
PART /p1 ext4 1T
PART /p2 ext4 1T
PART /p3 ext4 all
What am I doing wrong?
Thanks!
EDIT: disabling RAID works.
已采纳解答
原帖链接 · Tim Autin · CC BY-SA 4.0
So I finally got it working. I don't remember exactly what went wrong, but here's what I'm doing now:
1°) Use the following config (the /autoconfig file):
DRIVE1 /dev/sda
DRIVE2 /dev/sdb
#DRIVE3 /dev/sdc
SWRAID 1
SWRAIDLEVEL 1
BOOTLOADER grub
HOSTNAME EX61
PART swap swap 32G
PART /boot ext3 512M
PART / ext4 all
IMAGE /root/images/Ubuntu-2204-jammy-arm64-base.tar.gz
For other sample configs see the configs folder in Hetzner's installimage GitHub repo.
2°) Once installimage script has finished, but before rebooting, create mount folder & update fstab:
Create the mount folder:
mkdir /mountFolder
Update fstab:
cat > /etc/fstab
Paste:
proc /proc proc defaults 0 0
/dev/md/0 none swap sw 0 0
/dev/md/1 /boot ext3 defaults 0 0
/dev/md/3 / ext4 defaults 0 0
/dev/sdc1 /mountFolder ext4 defaults 0 0
Then reboot.
3°) If the /dev/md2 error occurs, format the SSD:
parted /dev/sdc mklabel gpt
parted /dev/sdc print unit MB print free
Note the size of the disk for the next command
parted --align optimal /dev/sdc mkpart primary ext4 0% 960197MB // replace the size here
mkfs.ext4 /dev/sdc1
Check if fstab needs to be updated again, if so do it:
cat /etc/fstab
(paste the same as in step 2)
Finally create the mount folder and mount the drive:
mkdir /mountFolder
mount -a
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
