问题原文
原帖链接 · Charlie Camilleri · CC BY-SA 4.0
Is it possible to expose an entire SCSI host dynamically (an LSI HBA or RAID card) over Fibre Channel, if so how?
Preferably on Linux (perhaps targetcli) and with disk hotplugging support. (i.e. unplug/replug a disk in the target and the initiator sees the change)
My FC HBAs are two QLogic QLA2462 cards.
已采纳解答
原帖链接 · BaronSamedi1958 · CC BY-SA 4.0
Sure you can do that. Good summary is here:
https://forum.level1techs.com/t/fedora-diy-fc-san/122877
Some good play with SCST instead of a default LIO is here (uses QLogic HBAs):
http://scst.sourceforge.net/qla2x00t-howto.html
In a nutshell: You can expose any physical or virtual block device as FC target.
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
