问题原文
原帖链接 · Alexander Taylor · CC BY-SA 3.0
In an otherwise fully IPv6 enabled network, can devices put behind Araknis switches use IPv6? I can't find any mention of IPv6 here: https://www.snapav.com/shop/en/snapav/araknis-switches
Araknis's only current router does support IPv6 (see Specs): https://www.snapav.com/shop/en/snapav/routers/araknis-networks-reg%3B-300-series-dual-wan-gigabit-vpn-router-an-300-rt-4l2w
I'm confused why they'd sell IPv6 routers but not IPv6 switches.
Context: I'm staying at a house with an Araknis router and separate Araknis switch. The router seems to support IPv6 according to its web interface but I can't physically access it to test plugging a device directly into it. But everything behind the switch doesn't seem to pick up an IPv6 address. On SnapAV's website, they don't mention IPv6 support on any of their switches, but their latest routers support IPv6 (mentioned in Specs section).
Update: Thanks for the answers everyone. The router was getting a public IPv6 from the ISP. I got access to the equipment and plugged a device directly into the router rather than the switch, and now it's getting an IPv6 address (though only a fc00::... unique-local address until I enabled prefix delegation on the router, after which it got an additional global address). So, it seems the switch is somehow the problem, despite the theory that it should be ignorant of IPv4 and IPv6. The switch that isn't working for me is an AN-100-SW-R-16 ("Araknis Networks® 100 Series Unmanaged Gigabit Switch with Rear Ports")
社区高分解答
原帖链接 · rnxrx · CC BY-SA 3.0
The link provided suggests that there are three levels of software switching: unmanaged, Web-based L2 and managed L2. The common point to all of these options is that the device doesn't support routing.
So - what this means is that any of these switches are going to happily pass frames, whether IPv6, IPv4 or IPX (just picking out a random non-IP example). What these switches won't do is route between different subnets (i.e. the switch won't act as the gateway for the subnet).
If you happen to connect an IPv6-enabled router (...to include the Araknis example you've mentioned) then it will be able to communicate with hosts on the L2-only switch to provide connectivity between subnets (..or to the greater Internet, if so equipped).
If v6 isn't working at your location I'd suggest focusing on the router configuration to see that there's both upstream connectivity and appropriate configuration on the interfaces. After this the question becomes proper support for RA, routing to the upstream, etc.
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
