问题原文
原帖链接 · Evan Carroll · CC BY-SA 4.0
I've purchased as x13sae motherboard from supermicro which is advertised as
M.2 Interface: 3 PCIe 4.0 x4 (RAID 0, 1, 5) M.2 Form Factor: 2280 M.2 Key: M-Key
I have two NVME dries in my m.2 ports. I want to put them RAID 1 so I can weather a drive failure. I don't see the option in the BIOS. Where do you configure this? I am using Linux. Is there a utility to configure hardware RAID?
社区高分解答
原帖链接 · Nikita Kipriyanov · CC BY-SA 4.0
Manual (available on the "Resources" page under your link) states there is a SATA RAID. I strongly suspect that is so called "fake" RAID, e.g. not a true hardware RAID. There is no explanation on how to set it up, but there is a link which targets to some collection of manuals, but only SATA or SAS RAIDs on SuperMicro motherboards.
There is a single mention of the RAID regarding these M.2 ports (out of 12 total mentions), on the page 52, in the form of the table column. No explanation of how to use it or where to look whatsoever.
You have to ask SuperMicro about that. Good luck.
Or... Are you going to use Linux? Then use its MD RAID. Or use one of its "RAID-enabled" file systems, BTRFS or ZFS. That's better than any "hardware RAID" that could be ever build into such a motherboard anyway. Seriously.
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
