问题原文
原帖链接 · Bastien974 · CC BY-SA 3.0
I have a Dell Poweredge R410 with Perc H200 controller.
I would like to upgrade my 15k RPM arrays with SSD. Both disks are SAS 6Gbps.
Will it work if I remove 1 of the 2 disks, replace by the SSD, wait for sync then replace the other one ?
HDD=600GB, SSD=800GB or 400GB. If the HDD only has 100GB used, will the controller by smart enough and allow the sync with a 400GB SDD ?
已采纳解答
原帖链接 · ewwhite · CC BY-SA 3.0
You cannot mix drive types in the same array group on PERC/LSI/HP hardware RAID controllers.
This also applies to mixing SATA, SAS and SSD.
"Mixing SAS and SATA drives within a virtual disk is not supported. Also, mixing hard drives and SSDs within a virtual disk is not supported."
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
