问题原文
原帖链接 · guettli · CC BY-SA 4.0
I found no way to remove a mdraid from a server with one command.
I can stop it via mdadm --stop /dev/md0
But the superblock is still in the devices.
mdadm --zero-superblock DEVICE needs every device (like /dev/sdb1)
I know that I can do mdadm --detail /dev/md0 and then I see the devices.
I could write a fragile script to fetch the /dev/sd... strings from the output of mdadm --detail /dev/md0, but I would like to avoid this.
Is there a one-liner to remove the superblock from all devices of a mdraid?
I would like to avoid to parse the output of mdadm --detail, since this feels fragile.
已采纳解答
原帖链接 · shodanshok · CC BY-SA 4.0
If you know the array component devices, you can simply issue something as
mdadm --zero-superblock /dev/sd[abcd]
to remove the superblock from multiple devices with a single command.
Please note that mdadm checks for superblock before zeroing anything, so specifying sd* in the command above should only touch component disks, without writing anything to the others. However, I strongly suggest against doing that: any issues in the superblock detection routing, or using --force, are going to overwrite good data on non-component disks (causing data loss). From the man page:
If the device contains a valid md superblock, the block is overwritten with zeros. With --force the block where the superblock would be is overwritten even if it doesn't appear to be valid.
For the reason above, if you don't know the array component devices I suggest listing them via
blkid -t TYPE="linux_raid_member" -o device
and then zeroing the specific disks with mdadm --zero-superblock. This can be scripted with a single-line bash command:
for dev in `blkid -t TYPE="linux_raid_member" -o device`; do echo "zeroing $dev"; mdadm --zero-superblock $dev; done
As always, triple-check any such commands to avoid data loss.
EDIT: to discover the array component devices without resorting to parsing of mdadm --detail output, you can use lsblk. For example, on a test array created via loop devices:
# lsblk -l -n -s /dev/md127
md127 9:127 0 255M 0 raid1
loop5 7:5 0 256M 0 loop
loop6 7:6 0 256M 0 loop
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
