大网数据广告活动
服务器运维问答

FreeBSD static routing set gateway to link

· 52CE 我爱测

I am running FreeBSD 8.1 and configuring static routes. What is the route command to set the gateway to link#1 and not an IP address? I tried route add default link#1 but FreeBSD doesn't take it. With Cisco IOS it's possible to r…

问题原文

原帖链接 · T. Webster · CC BY-SA 3.0

I am running FreeBSD 8.1 and configuring static routes. What is the route command to set the gateway to link#1 and not an IP address?

I tried route add default link#1 but FreeBSD doesn't take it. With Cisco IOS it's possible to route to a next-hop gateway this way with ip route. For example, Cisco IOS will take ip route 172.16.2.0 255.255.255.0 Serial 0/0. What is the equivalent UNIX command to do the same?

I statically configured netif em0 to 172.16.1.102 The state of my FreeBSD instance shows link#1 exactly once as follows.

Destination     Gateway
...
localhost      link#3    UH   ...    lo0
172.16.1.0     link#1    U    ...    em0

...

已采纳解答

原帖链接 · voretaq7 · CC BY-SA 3.0

You need to stop, take 10 giant steps back from the machine, and read the FreeBSD handbook section on networking (specifically the section on Gateways and Routes).

. . . go ahead, this answer will still be here when you're done. . . .

You read it? Good.
Now you understand that what you're asking to do makes no sense, right?


FreeBSD generally handles routes two ways:

  1. I am connected to this network directly, via a NIC (interface, link)
    The system knows this because when you configure an interface you provide an IP address and a netmask. Any machines on the subnet specified by that combination are reachable over that link.

  2. I can reach this network via a gateway machine with a specific IP address
    The system knows this because you configure a route to a specific destination (a single address, a subnet, or the "default" route for any destination not otherwise specified), and tell it which machine (address) will be the gateway that it should send traffic to in order to reach that destination.
    Implicit in this is that you must be able to reach this gateway (either via a link as in (1) above, or via another gateway.

You cannot configure a link as a gateway - doing so makes no sense as any network(s) reachable via a specific link will be automatically configured for you when you configure the interface.

You can do other things (like simply spew traffic onto a serial line), which are all documented in the handbook if you're actually in one of the rare situations where you would need to, but you've given no indication that you're in such a situation.

摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。

资料来源与适用范围

资料来源
Server Fault
适用范围
以原帖系统、软件版本与发布日期为准(2013-04-12)
内容语言
中文;命令、路径和错误标识保留技术原文
本地收录日期
2026-11-15
授权说明
CC BY-SA 3.0

正文与所需资源由本站本地存储。查看来源及更新记录 ↗

请按适用版本和实际日志确认原因;本站没有对每一种系统或设备逐项执行文中的操作。