大网数据广告活动
服务器运维问答

firewall-cmd not allowing loopback redirect

· 52CE 我爱测

I am trying to redirect a port on the loopback interface, but it does not seem to be working firewall-cmd --list-all-zones trusted (active) target: ACCEPT interfaces: lo ... rich rules: rule family="ipv4" source address="127.0.0.…

问题原文

原帖链接 · Jamie · CC BY-SA 4.0

I am trying to redirect a port on the loopback interface, but it does not seem to be working

firewall-cmd --list-all-zones

trusted (active)
target: ACCEPT
interfaces: lo
...
rich rules:
    rule family="ipv4" source address="127.0.0.1" forward-port port="400" protocol="tcp" to-port="500"

but when I run nc -v 127.0.0.1 400 I get connection refused. nc -v 127.0.0.1 500 can connect fine.

Any advise for how to get this set up correctly? Thanks

已采纳解答

原帖链接 · Piotr P. Karwasz · CC BY-SA 4.0

firewalld installs a rule in the PREROUTING chain of the nat table. This table is consulted only for foreign traffic.

Locally generated traffic traverses the OUTPUT chain of the nat table, so you need to install a rule with:

firewall-cmd --direct --add-rule ipv4 nat OUTPUT 0 -s 127.0.0.1\
-p tcp --dport 400 -j REDIRECT --to-port 500

摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。

资料来源与适用范围

资料来源
Server Fault
适用范围
以原帖系统、软件版本与发布日期为准(2020-02-26)
内容语言
中文;命令、路径和错误标识保留技术原文
本地收录日期
2026-11-15
授权说明
CC BY-SA 4.0

正文与所需资源由本站本地存储。查看来源及更新记录 ↗

请按适用版本和实际日志确认原因;本站没有对每一种系统或设备逐项执行文中的操作。