问题原文
原帖链接 · Philip Rego · CC BY-SA 4.0
I tried this, but it's only a partial answer or not right for CentOS7. https://serverfault.com/a/320624/439512
I did exactly what it says but it's not right.
$ sudo iptables -A INPUT -i eth0 -p tcp --dport 80 -j ACCEPT
$ sudo iptables -A INPUT -i eth0 -p tcp --dport 8080 -j ACCEPT
$ sudo iptables -A PREROUTING -t nat -i eth0 -p tcp --dport 80 -j REDIRECT --to-port 8080
$ curl localhost
curl: (7) Failed connect to localhost:80; Connection refused
$ curl localhost:8080
<html>...</html>
$ sudo iptables -L
Chain INPUT (policy ACCEPT)
target prot opt source destination
ACCEPT tcp -- anywhere anywhere tcp dpt:http
ACCEPT tcp -- anywhere anywhere tcp dpt:webcache
Chain FORWARD (policy ACCEPT)
target prot opt source destination
Chain OUTPUT (policy ACCEPT)
target prot opt source destination
These two commands will work termporarily but not after restart:
sudo iptables -t nat -A PREROUTING -p tcp --dport 80 -j REDIRECT --to-port 8080
sudo iptables -t nat -I OUTPUT -p tcp -d 127.0.0.1 --dport 80 -j REDIRECT --to-ports 8080
If you try to save it like this guy says it'll completly break and it won't even work temperarily:
$ sudo systemctl enable iptables
$ sudo service iptables save
$ sudo iptables -t nat -A PREROUTING -p tcp --dport 80 -j REDIRECT --to-port 8080
$ sudo iptables -t nat -I OUTPUT -p tcp -d 127.0.0.1 --dport 80 -j REDIRECT --to-ports 8080
$ sudo service iptables save
iptables: Saving firewall rules to /etc/sysconfig/iptables:[ OK ]
$ sudo iptables -L
Chain INPUT (policy ACCEPT)
target prot opt source destination
Chain FORWARD (policy ACCEPT)
target prot opt source destination
Chain OUTPUT (policy ACCEPT)
target prot opt source destination
Does anyone have a working example on how to do this?
已采纳解答
原帖链接 · Ryan · CC BY-SA 4.0
Use the following command and post the error if you have any trouble.
Make sure the post is allowed and open by iptables and then:
iptables -A PREROUTING -t nat -i eth0 -p tcp --dport 80 -j REDIRECT --to-port 8080 --permanent
sudo firewall-cmd --zone=public --add-port=80/tcp --permanent
sudo firewall-cmd --reload
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
