问题原文
原帖链接 · Nyxynyx · CC BY-SA 4.0
On Ubuntu 20.04, I am trying to establish a VPN tunnel to a IKEv2/Ipsec VPN site using Strongswan.
However, even though I have the file /etc/ipsec.conf as shown
# ipsec.conf - strongSwan IPsec configuration file
# basic configuration
config setup
# strictcrlpolicy=yes
# uniqueids = no
conn foo
left= ...
right= ...
...
when I run sudo ipsec up foo, I get the error
no config named 'foo'
I have tried the follow commands before running ipsec up foo, but the error persists.
sudo ipsec update
sudo ipsec reload
sudo ipsec restart
Strongswan U5.8.2/K5.4.0-60-generic was installed using
sudo apt-get install strongswan libcharon-extra-plugins -y
What seems to be preventing the foo connection from being detected?
Thanks!
已采纳解答
原帖链接 · ecdsa · CC BY-SA 4.0
Connections defined in ipsec.conf are only loaded if auto is configured to anything but the default value, which is ignore.
A connection may simply be loaded (add) without starting it (e.g. as responder for roadwarriors), automatically started (start), or trap policies (based on left|rightsubnet) can be loaded into the IPsec stack/kernel (route) so matching traffic triggers the tunnel automatically.
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
