问题原文
原帖链接 · Server Fault · CC BY-SA 3.0
I'm running AMANDA with an LTO-6 drive spooling off a local RAID array. The backups are beginning to take longer than the eight hour backup window. Are there any config options to cut some time off the backups (The disks are spiking near 100% utilization for minutes at a time so the upgrade would likely involve a faster RAID array. Possibly more RAM). Other than disks, I don't think the hardware is bottlenecking; CPU utilization is 30% and under, RUNQ is 8 or under (16 core system) and disk swap use is 60Kb and under.
Here is my config. I'm not sure the netusage parameter does anything since these are all local files to the drive. Any obvious config changes to speed things up? Would inparallel help with more RAM?
inparallel 6
dumporder "sssS"
taperalgo first
displayunit "m"
netusage 600 Kbps
dumpcycle 1 week s
runtapes 1
runspercycle 1
tapecycle 17 tapes
已采纳解答
原帖链接 · Jayk529 · CC BY-SA 4.0
Thank you for your question regarding Amanda.
While backing up data to Tapes, it is always recommended not to use the software compression. Most Tape drives have hardware compression available and this normally provides good compression ratio at fast rates. Enabling both software and hardware compression would delay your backups significantly.
If you have any other questions, feel free to let us know.
Zmanda Support
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
