问题原文
原帖链接 · TCB13 · CC BY-SA 3.0
I've updated a machine to Debian 9.1 and everything seems to be fine, however I can't disable IPv6 autoconfig.
Background: I only want to use some specific IPv6 addresses on the machine that I'm defining in /etc/systemd/network/10-static-eth0.network:
[Match]
Name=eth0
[Network]
Address=2a04:52c0:xxx:xxx::xxx/48
Address=2a04:52c0:xxx:xxx::xxx/48
Address=2a04:52c0:xxx:xxx::xx/48
Gateway=2a04:52c0:xxx::1
Address=5.2.xxx.xxx/25
Address=5.2.xxx.xxx/25
Address=5.2.xxx.xxx/25
Gateway=5.2.xxx.xxx
To disable IPv6 autoconfig I added the following at the end of /etc/sysctl.conf:
net.ipv6.conf.default.autoconf=0
net.ipv6.conf.all.autoconf=0
net.ipv6.conf.eth0.autoconf=0
net.ipv6.conf.default.accept_ra=0
net.ipv6.conf.all.accept_ra=0
net.ipv6.conf.eth0.accept_ra=0
net.ipv6.conf.default.accept_dad=0
net.ipv6.conf.all.accept_dad=0
net.ipv6.conf.eth0.accept_dad=0
After rebooting there's no dynamic / autoconfig IPv6 address but after a while it appears on ip addr show:
inet6 2a04:52c0:xxxx:xxxx:xxxx:xxx:xxxx:1e3d/64 scope global mngtmpaddr noprefixroute dynamic
valid_lft 2590732sec preferred_lft 603532sec
How can I avoid this autoconfig IPv6 address and make sure only the static addresses get to work?
Thank you.
已采纳解答
原帖链接 · Pablo · CC BY-SA 3.0
I believe these addresses marked as mngtmpaddr and noprefixroute come from the IPv6 Privacy Extensions standard (RFC 4941) and are created by the kernel itself.
You should be able to turn that feature off adding
net.ipv6.conf.default.use_tempaddr=0
net.ipv6.conf.all.use_tempaddr=0
net.ipv6.conf.eth0.use_tempaddr=0
to your /etc/sysctl.conf
Hope it helps!
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
