问题原文
原帖链接 · cyberquarks · CC BY-SA 4.0
So I managed to install ZeroTier with the Ubiquiti Edge Router X via:
admin@edgerouter# sudo -i
root@edgerouter:~# curl -s https://install.zerotier.com | sudo bash
And got to access the Edge OS (Edge Max) interface through the ZeroTier Global IP, so I can access my router anywhere in the world which is great.
However, how can I access the LAN devices connected to the router? For example, I have one device with Local IP in the router, 192.168.1.39
How can I access this using the ZeroTier network?
已采纳解答
原帖链接 · cyberquarks · CC BY-SA 4.0
Here's the solution:
- Update the Ubiquiti EdgeRouter-X (ER-X) with Firmware 2.0.8 (you can Google this very easily)
- Install ZeroTier from the command line (Skipping the device mapping)
ubnt@edgerouter# sudo -i
root@edgerouter:~# curl -s https://install.zerotier.com | sudo bash
At this point the ER-X is unable to "interact" with ZeroTier so we need to patch.
- Patch with the zerotier-edgeos (by Dennis Kruyt) Download this file from https://github.com/dkruyt/resources/raw/master/zerotier-edgeos.tgz
root@edgerouter:/# tar -C / -xvzf /home/admin/zerotier-edgeos.tgz
At this point after reboot the ZeroTier interface will now show in the router dashboard.
- Setup DNAT and SNAT rule in the ER-X router, taking into account the Upstream IP address and the ZeroTier IP address and the switch0 address, additionally, to keep the setup simple a Network Group was created, the Upstream and ZeroTier group respectively (nothing special here just set the Group following the standard Ubiquiti guide
Then
ubnt@edgerouter# configure
edit service nat rule 1
set description "ZeroTier DNAT"
set destination group network-group ZeroTier
set inbound-interface ztzlgezugz
set inside-address address 192.168.0.157
set log disable
set protocol all
set type destination
top
edit service nat rule 5000
set description "ZeroTier SNAT"
set log disable
set outbound-interface ztzlgezugz
set outside-address address 10.147.17.15
set protocol all
set source group network-group Upstream
set type source
top
commit
save exit
Where the IP 192.168.0.157 is the upstream IP i.e. eth0 and the 10.147.17.15 is the ZT IP
- Setup Managed Route in ZeroTier:
Note: 192.168.1.0/24 here is the switch0 address where the LAN devices are connected, eth1, eth2, eth3 and eth4 in my case since I have ER-X router
Done.
From here, you will be able to access the LAN devices connected to switch0 over the internet.
References:
- https://blog.kruyt.org/zerotier-on-a-ubiquiti-edgerouter/
- https://kruyt.org/zerotier-on-edgerouter-p2/
- https://community.ui.com/questions/How-to-bridge-two-network-interface/b74f4c6e-dbea-4587-bd53-3ce8acdf9b6b
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
