问题原文
原帖链接 · Silvian Cretu · CC BY-SA 3.0
I'm trying to set up a LAN-to-LAN IPsec tunnel and at one endpoint I have an old CISCO 871W running IOS 12.3(8)YI2. The command "tunnel mode ipsec ipv4" doesn't work:
router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
router(config)#interface tunnel 1
router(config-if)#tunnel mode ipsec ipv4
^
% Invalid input detected at '^' marker.
router(config-if)#tunnel mode ?
aurp AURP TunnelTalk AppleTalk encapsulation
cayman Cayman TunnelTalk AppleTalk encapsulation
dvmrp DVMRP multicast tunnel
eon EON compatible CLNS tunnel
gre generic route encapsulation protocol
ipip IP over IP encapsulation
iptalk Apple IPTalk encapsulation
nos IP over IP encapsulation (KA9Q/NOS compatible)
Any ideas why? Thanks!
已采纳解答
原帖链接 · hertitu · CC BY-SA 3.0
The Cisco IOS Interface and Hardware Component Command Reference tells us that this command was introduced in 12.3(14)T which is quite old, but unfortunately your IOS version is just a tiny bit older than that.
Edit: unless you can upgrade the router, depending on your use case (and what the other router supports), you can instead use:
- a regular (crypto map based) L2L tunnel
- a 'classic' GRE/IPsec tunnel (if you need to have a Tunnel interface for e.g. a routing protocol), where IPsec is done using a crypto-map
- a GRE/IPsec tunnel with Tunnel Protection.
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
