问题原文
原帖链接 · Gediz GÜRSU · CC BY-SA 4.0
Is it possible to connect all 24 disks to one raid card ? How do I connect these physically ? Do I need an expander ? Or is it-mode flushing sufficient ? I read it-mode flushing permits up to 1024 drives and software raid. (mdadm bcache megacli etc usage is not a problem ?
The Hardware I got :
- OS : Linux
- Backplane : BPN-SAS3-846EL-1 https://www.supermicro.com/manuals/other/BPN-SAS3-846EL.pdf
- Raid Cards : LSI 9260-8i , 2 x LSI 2108 pci-e x8
- Cable: SFF-8643 to SFF-8087
已采纳解答
原帖链接 · Gediz GÜRSU · CC BY-SA 4.0
It turns out board has built in sas expander , I was able to connect 24 disks into one lsi 2108 and without it mode flushing choosing raid1 (it creates raid 10 automatically) they work as expected. Benchmarks show 1.5 GB per second read and write. A little low than I expected since each disk is rated 250mb/sec read speed. Used linux disks utility , hdparm and dd for benchmark. Cache was enabled didnt see much difference adding sofwtware striped sdd caches (bcache) with 1MB cutoff in small files copy, other than slightly increased IO. Tested this copying random sized files created with dd if=/dev/urandom smaller than 1MB, timed with time command of bash. This was my first setup, I have seen cards and cables first time in my life. Answer is although documentation does not state clearly up to how many disks a cable or an adapter or a built in backplane expander supports and although many people insist that it-mode firmware flushing is required , they work out of the box.
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
