问题原文
原帖链接 · JamesTheAwesomeDude · CC BY-SA 3.0
I have a Cisco ASA 5510, running ASA software version 9.1(7)16 on an IPv6 LAN.
I want to enable SSH access, but I'm running up against the following warning:
ciscoasa(config)# show ipv6 interface management
IPv6 is enabled, link-local address is fe80::21d:a2ff:fe59:4b97
No global unicast address is configured
Joined group address(es):
ff02::2
ff02::1
ff02::1:ff59:4b97
ICMP error messages limited to one every 100 milliseconds
ICMP redirects are enabled
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised retransmit interval is 1000 milliseconds
ND router advertisements are sent every 200 seconds
ND router advertisements live for 1800 seconds
Hosts use stateless autoconfig for addresses.
ciscoasa(config)# ssh fe80::/64 management
WARNING! This command will not take effect until interface 'management' has been initialized with at least one global IPv6 address
ciscoasa(config)#
(SSH connections to this address fail, although when I configured and tested an IPv4 address, it was able to connect)
So, my question is: what do I need to do to allow SSH connections to my ASA 5510's link-local IPv6 address?
I don't care if I have to e.g., set up a dummy address in the "Documentation Only" IPv6 range to get it to fire up the SSH IPv6 stack, or statically assign the link-local address, or what: I just need to be able to access it on the same subnet as the rest of the devices in this environment.
已采纳解答
原帖链接 · shouldbeq931 · CC BY-SA 3.0
Hopefully obviously, the interface needs to be enabled for IPv6
ipv6 enableA static IPv6 address needs to be configured on the interface, this static address can be a documentation (rfc3849) address, or a statically assigned link local address, or a public address (even if not publicly routable
ipv6 address 2001:db8::/32
摘自公开归档,保留原文语言,版式经整理,外部媒体与邮箱地址已移除。
