Summary
This article helps you fix an issue that prevents you from extending a disk volume because the requested size requires more clusters (also known as allocation units) than the file system supports. The article includes resolution steps to adjust the target volume size, create an additional volume, or reformat the volume.
Symptoms
When you try to extend an existing disk volume, you receive an error message that resembles the following example:
The volume cannot be extended because the number of clusters will exceed the maximum number supported by the file system.
In this scenario, there are no recent configuration changes or system updates, and no other issues occurred that require troubleshooting.
Cause
This issue occurs because the file system limits the number of clusters that a single volume can have. The number of clusters in a volume depends on the size of the volume and the size of the clusters. The maximum number of clusters per volume depends on the file system, such as NTFS (New Technology File System) or FAT32 (File Allocation Table 32), and the version of Windows. For more information, see the Support for large volumes section of "NTFS overview."
If the requested volume size requires more clusters than the supported limit allows, the file system can't use all the available space. Therefore, Windows doesn't allow the extension.
Resolution
To resolve this issue, use one of the following methods:
-
Adjust the target volume size. Reduce the amount by which you want to extend the disk so that the number of clusters stays within the supported limit of your current file system.
[!NOTE]
If you aren't sure about the cluster limits for your file system, see the following resources:- Description of Default Cluster Sizes for FAT32 File System
- Support for large volumes in "NTFS overview."
-
Create and use an additional volume. If reformatting the volume isn't an option, create an additional volume instead of extending the existing one.
-
Reformat the volume. If it's feasible to reformat the volume, you can change the file system that the volume uses. For example, NTFS supports higher cluster limits than FAT32.
[!IMPORTANT]
-
Before you reformat the volume, back up any data in the volume. Reformatting deletes all data in the volume.
-
As the volume size increases, the default cluster size also increases while the number of clusters per volume decreases. If you're using NTFS or the Resilient File System (ReFS), you can change the cluster size when you reformat the volume. However, this change might introduce performance issues and might not help resolve the cluster-per-volume limit issue. For more information, see the following resources:
- Support for large volumes in "NTFS overview."
- Cluster size is too large in "Locate and correct disk space problems on NTFS volumes."
- Cluster size recommendations for ReFS and NTFS.
-
Data collection
If you have to contact Microsoft Support for assistance, gather the following information:
- A screenshot of the Disk Management tool that shows all the partitions and unallocated space.
- The version of Windows that you're using. To find this information, go to Settings > System > About.
- The file system type of the affected volume (for example, NTFS, FAT32, exFAT).
- The current size of the volume, and the size that you tried to extend it to.
- The exact error message that you received when the extension failed.
- Any recent changes to the storage configuration or hardware.
To collect information about the volume, use the Disk Management tool or the diskpart command-line utility. For example, open an administrative Command Prompt window, and then run the following commands:
diskpart
list volume
Identify the affected volume in the list, and then run the following commands:
select volume <VolumeNumber>
detail volume
Note:
In these commands, <VolumeNumber> represents the number that's assigned to the volume in the list.
References
- Disk Management in Windows
diskpart- NTFS overview
- Locate and correct disk space problems on NTFS volumes
- Cluster size recommendations for ReFS and NTFS
- Description of Default Cluster Sizes for FAT32 File System
Source: Microsoft Learn / IT Pro troubleshooting by Microsoft and contributors. Documentation licensed CC BY 4.0. Code samples are covered by the MIT License. Converted from Markdown, with links normalized and embedded media omitted.
